FACTS:                          

 Built in Canada

• 25 year mat warranty
• 3 year thermostat warranty
• Hundreds of standard sizes in both 120V and 240V
• 1/8” thick
• 12 – 15 Watts per square foot
• Approved  by ETL to the latest CSA standard

 

 Where to Use:            

 All tile and natural stone, laminate and engineered wood

 

 Do not Use:                

 Under carpet; solid wood, directly under linoleum, vinyl or outdoors

 

Coverage:

 Per electrical circuit – approximately 150 square feet in 120V and 300 square feet in 240V

• Larger areas  would require a second circuit

 Tips:                             

 Use a modified thinset mortar

• Do not run the mat until the mortar is cured
• The heat radiates up from the mat, but not beyond the edge of the mat.
• Stay close to toe kicks
• Recommend to insulate floor over slab on or below grade or unheated crawl space to reduce heat loss.
• Remove mortar from grout lines while still wet when laying tile
• Set thermostat probe 12” into the mat area
• Ensure probe will not be in sunlight or covered by a fixture as this may cause early shut down of the thermostat
• On an engineered wood installation ensure that the thermostat is not run above 28C or 82F temp

 

 Mat Test:                     

 Test, before, during and after the installation process

• Set your meter to ohms
• Black and white on 120V mat to the two meter clamps
• Black and red on 240V mat to the two meter clamps
• The reading on the meter should be + / – 20% of the ohms value on the mat label.

 Questions?                

  Call 1-519-650-3737